Conergy SolarSimplex4.1 - solar panel mounting system

Conergy SolarSimplex has been designed for simple, flexible and professional installation on flat roofs. The system consists of a plastic tub, two aluminium supporting bars and the necessary screws. Weighing only about 4 kilograms,Conergy SolarSimplex is easy to stack and transport. Mounting is limited to packing the tub with ballast, e.g. gravel or paving stones, and attaching the supporting bars and modules.

Flexible application: SolarSimplex is primarily designed for gravel-covered flat roofs. However, it can also be used with virtually all types of common rough roof covering.

Rapid mounting: All components are pre-fitted according to the chosen PV module. Their light weight makes for simple and low-cost transportation to the roof. Integrated channels for cable routing further simplify assembly.

Individual array: The PV modules are placed individually, allowing the most diverse arrangements. As a result, SolarSimplex offers optimal adaptability to the given roof surface.

High module compatibility: The SolarSimplex allows easy flat roof mounting of virtually all conventional PV modules between 70 and 165 watt peak. For larger modules, an extension kit for the supporting rails can be obtained.

Optimized design: The space between the PV module and the SolarSimplex guarantees optimum rear ventilation. At the same time, the supporting bars guarantee good load transmissioninto the tub.

Warranty

• 10 Year warranty on the durability of all materials

Technical Specifications

Technical Characteristics
Range of application			Flat roofs
Roof covering			Suitable for virtually all types of rough1 roof covering
Pitch			25°
Roof load			Following clearance by structural engineer
Height of building			Up to 8 m
Snow load			Up to 0.75 kN/m² (2)
PV modules			Framed
Module configuration			Individual (one module per tub)
Module orientation			Landscape
Size of module field			Any size possible
Positioning on the roof			No special requirements²
Plastic tub			100% chlorine-free, recycled polyethylene (HDPE)
Supporting bars			Extruded aluminium (AlMgSi 0.5)
Small parts			Stainless steel (V2A)
Weight			4–5 kg
Colour			Black
Lightning protection			Optional, with surcharge
Mechanical Characteristics
Dimensions in mm
Type		A	B	C	D	Ballast³
SolarSimplex 4.1		1600	800	450	85	73 kg
Hole intervals in module frame - mm
Without Extension Set			With Extension Set
SolarSimplex 4.1	Min	Max	Max
	661	781	851

¹ For detailed information, please contact Energy Matters during the planning stages of your project.
² Please note: Wind load can be considerably increased when installing in edge and corner areas of the roof. Please contact Energy Matters during the planning stages of your project.
³ Attention: Other values may be required depending on the site and roof type. For further information, please contact a local structural engineering.