Selectronic Ps1 5000watt 24volt 200amp Inverter Charger

Selectronic PS1 Interactive Inverter Charger 5000Watt 24Volt 200Amp

The Interactive Advantage
True NO Break power Unlike many other Inverter Chargers, the PS1 will operate in parallel with a generator or grid electricity. As the generator slowly seizes the load, the PS1 starts to charge the batteries or support the load. The result is True NO Break performance when under PS1 control. Parallel operation of 2 PS1 units is possible using split AC actives. Enquire for more information

The real Outback performer
The PS1 has been developed after many years of experience in the hostile and remote environments of outback Australia. This experience, hours of thermal modeling and many hours of field trialling give you the confidence that a PS1 is built to last. The power module has a massive number of ideally placed primary capacitors, these are connected via ultra low impedance 4oz copper circuit board instead of the typical 1oz.

Information, Information
The amount of data stored inside the PS1 is nothing short of amazing. Up to 32 recent alarms are stored for quick viewing on the LCD screen, and up to 200 alarms when viewed using Remote Link software via a computer. This information makes it simple for system interrogation locally or via a modem remotely.

Warranty

Standard 3 year warranty

Technical Specifications

PS1 Model	PS1 5-24
Inverter Mode
Battery voltage nominal	24V DC
Continuous output at 25°C "TRUE POWER"	5.0 KW
Max output power 30 mins "TRUE POWER"	6.0 KW
Max output power 5 mins "TRUE POWER"	6.5 KW
Max overload 0-5 secs "TRUE POWER"	8.0 KW
Max surge	9.6 KW
Max continuous output interactive mode	Continuous inverter output + generator output
Power save sensitivity range	10-40 W
Output voltage/frequency invert mode	Adj 220-240V +1%/-4%, 50Hz ± 0.1% @ <4% THD
Interactive Mode
Changeover time, invert to generator when inverter controlled	Zero
Load auto switched to generator in fault mode	Yes
Max adjustable charge rate	0-200 A
No of charge stages/Charger type	4 stages, plus equalize & recovery. Unity PF: 4 state constant I, constant V with current & power limit
Generator Start Parameters
4 x time of day, 3 x state of charge, 2 x adjustable power limits, 4 x back up times. Battery voltage, inverter shutdown, Inverter temperature Generator start method 2 or 3 wire, pulsed or run signal (adj)
General
Dimensions	585H x 400W x 420D mm
Weight	72 kg
Communications serial interface	RS232 x 2400bps
Memory retention of settings and logged data	Permanent via on board battery backed RAM & EEPROM
No of shunts	1 x 100A internal, 1 x optional external shunt
Peak efficiency	91 %
Minimum generator required	8.7 KVA
Enclosure rating	IP40
On board log	Records over 200 events, alarms and data which can be accessed remotely via serial port/modem with optional Remote Link software. Up to 32 current day events on LCD
Four line alphanumeric backlit LCD displays:	configuration parameters, Batt Volts, Nett Batt Amps, AC Load kW, Gen kW/Volts/Freq, Av daily kWh, Shunt 1&2 Amps, Event log, Charge Amps, State of Charge
Warranty	3 year or plus additional 3 year optional